Quick Answer: How do you adjust Hunter rain sensors?

The Mini Clik uses a spindle adjustment to set the amount of rain you want the sensor to witness before it shuts down the system. This amount can be set by adjusting the spindle on top of the sensor and the range is 1/8″ (3.17mm) to 1″ (25.4mm).

How do you adjust a hunter Mini Clik rain sensor?

The Mini Clik uses a spindle adjustment to set the amount of rain you want the sensor to witness before it shuts down the system. This amount can be set by adjusting the spindle on top of the sensor and the range is 1/8″ (3.17mm) to 1″ (25.4mm).

How do I reset my Irritrol rain sensor?

Open the battery compartment and disconnect the battery. Press and hold the Manual button in and KEEP HOLDING IT IN while performing the next step. Reconnect the ribbon cable, then release the Manual button. Note: The display should now show 12:00 AM indicating the controller has reset.

Does the Hunter rain sensor have a battery?

If the receiver Sensor Status light is green, the battery in the transmitter is good. … Release the quick response spindle on the transmitter. The receiver Sensor Status should change back to (GREEN – Sensor is dry). If the receiver Sensor Status does not change, try readdressing the transmitter with the receiver.

IT\'S FUNNING:  Who said right as rain in a movie?

How do you test Rainbird rain sensor?

Testing the System

Once installed, the completed system can be tested by turning on any controller irrigation zone, verifying that zone does come on, and then pressing down on the Rain Sensor pin located on the top of the dial cap. The irrigation system should stop watering within a few seconds.

How long do rain sensors last?

How long do rain sensors last? The average rain sensor only functions for 3-5 years before needing replacement.

What is Hunter Solar Sync?

The Solar Sync ET sensor is an advanced weather sensor that calculates evapotranspiration (ET) and adjusts Hunter controllers daily based on local weather conditions. Solar Sync measures sunlight and temperature, and uses ET to determine the correct seasonal adjustment percentage value to send to the controller.

What is the rain sensor for on windshield?

Most rain-sensing wipers use a sensor that’s mounted behind the windshield. It sends out a beam of infrared light that, when water droplets are on the windshield, is reflected back at different angles.